Jig Package

Description

Jig Package includes wing jigs, canard jigs, and winglet jigs.

Wing Jigs – Available Now

Precision CNC wing jigs are now available. These are made from 3/4″ MDF using a CNC router. They are designed to work the same way the plans jigs work but were developed by taking cross sections of a 3D wing model in CAD. They should fit much better than the plans jigs but still follow the plans jigging method. They are designed to be a tight fit to hold them firmly in place. A very flat building surface is required (not a shop floor as shown below).

All Joiner plates are provided (also CNC cut). These fit into depressions milled into the jig itself to improve the alignment and strength of the joint. Joiners should be glued in place one one side and bolted on the other per the plans. Bolts, washers, and nuts are included to bolt one side of each joiner to the jig.

Canard Jigs – Available Now

All jigs, contour templates, and alignment templates for the Roncz canard are now available.
This is a 21 piece kit that includes all of the following:
E – Canard Bottom Contour Checking Template
F – Canard Top Contour Checking Template
G – Elevator Travel Checking Template
H – Top Elevator Contour Checking Template
| – Bottom Elevator Contour Checking Template
J – 2 Outboard Mass Balance Mounting Jigs
K – 9 Canard Jigs
L- 4 Elevator Mounting Templates
M – Canard Tip Shaping Template
These are all precision cut from MDF and plywood using a CNC router.

Winglet Jigs – Available Now

These jigs are used for doing the outside skin layup on the upper winglets. The foam scraps included with the winglets are used to do the inside skin layup. The jigs are precision cut using a CNC router from 1/2″ MDF.